Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-320 © SAMSUNG Electronics Co., Ltd.
836 H.323 GK Options
Provides a means to set the H.323 gatekeeper parameters for an optional external
industry-standard H.323 network gatekeeper, using Registration, Admissions, and
Status signalling(RAS). The settings are system wide.
When changing any IP address/value, listed below, three digits must be input for each
(octet) field. Example) 192.168.1.10 input must be : 192 168 001 010
No Option Description
00 GK CONNECTION This enables or disables the H.323 call to connect to a gatekeeper.
Default is DISABLE.
01 GK ROUTING This enables or disables routing of calls through a gatekeeper.
Default is DISABLE.
02 GK IP ADDRESS This is gatekeeper’s IP address. Default is 0.0.0.0
03 GK NAME This is alphanumeric name identifier of the gatekeeper. An entry of
16 characters. Default is ‘Gatekeeper’.
04 ALTER GK IP ADDR This provide for an alternate gatekeeper address. Default is 0.0.0.0
05 H.323 GATEWAY ID This is the H.323 identifier used by the MGI when registering with
the gatekeeper. This can be up to 32 characters. Default is
‘OfficeServ 12’.
06 E.164 GATEWAY NO This is the E.164 identifier used by the H.323 trunk when registering
with the gatekeeper. This can be up to 16 digits in length.
07 GK KEEP ALIVE This is the timer that the MGI uses to acknowledge the presence of
the gatekeeper. The range is 000-999 seconds. Default is 0 SEC.
08 GK DOWN ROUTE This provides an alternate route in case the primary gatekeeper is
down. Selections are PSTN or ALTER GK. Default is PSTN.
09 GK RAS TYPE Select if AUTO or MANUAL, depending on your gatekeeper’s
capabilities. Default is AUTO.
11 URQ REASON
MODE
Select ON or OFF for usage of Un-register Request RAS(URQ)
messages. Default is ON.
12 RRQ FAIL TIME Programs the time frame to re-send Registration Request RAS
(RRQ) messages to a gatekeeper. Default is 30 seconds.
The range is 1-99.
13 GRQ SEND Select ON or OFF for usage of Gatekeeper RAS Request(GRQ)
messages. Default is OFF.