Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

No Option Description

11 INV.NO RESP TIME Before sending Cancel for the Invite Request, the User Agent shall

wait for this amount of time. The range is 0-99900ms. Default is

5000ms.

12 GEN.NO RESP TIME Before sending Cancel for General Request, the User Agent shall

wait for this amount of time. The range is 0-99900ms. Default is

5000ms.

13 REQ.RETRY TIME After sending General Request, the User Agent shall wait for the

Final Response for this amount of time. The range is 0-99900ms.

Default is 5000ms.

14 SIP SERVER ENBLE Sets ENABLE or DISABLE to use an optional external industry-

standard SIP Server. Default is DISABLE.

15 SIP SERVER IP Sets SIP server IP address. Default is 0.0.0.0.

16 SIP SERVER PORT Sets the port to use on the SIP Server. Default is 5060.

14 SIGNAL PORT Indicate the port number for SIP signalling and sets a range of

numbers allowed by firewall equipment. The common and default

IP path or port used is 10000.

18 SEND CLIP TABLE Refers to SEND CLI NUMBER(MMC323), which provides calling

party identification when using the MGI as a SIP gateway.

This provides station ID of the calling station. A single digit value

corresponding with the desired table in MMC323 should be entered

here. This is only used when MMC405 value is null. Default is1.

19 INCOMING MODE This option selects how incoming calls are routed when the MGI is

used as a SIP gateway.

0 FOLLOW TRUNK RING : Follows MMC406

1 FOLLOW DID TRANS : Follows MMC714(default)

2 FOLLOW INCOM DGT : Follows MMC724

20 ALLOW GW CHECK When using a gatekeeper, this permits the SIP gateway to check

for gatekeeper presence. Default is DISABLE.

PROGRAM BUTTONS

VOLUME Used to scroll through options

KEYPAD Used to enter selections

SOFT Move cursor left and right

SPEAKER Used to advance next MMC