Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming
© SAMSUNG Electronics Co., Ltd. Page 2-325
840 IP Phone Information
This MMC provides a means to register the IP phones with the OfficeServ 12 system.
During registration, the IP and MAC addresses are also registered. The User ID and
Password must match the table entry in this MMC for the IP phone to be registered.
The system made default phone numbers are 3201-3299 and made default User ID’s
match the default station numbers(3201-3299). The system default password is 1234.
IP phones must be individually programmed with User ID and Password to register
with the system.
No Information Description
00 USER ID This is the ID the IP phone must match to register with the OfficeServ 12
system. This entry can be alphanumeric.(Default: first 99 IP phones are
‘3201’-‘3299’, others are EMPTY)
01 USER PSWD This is the Password the IP phone must also have to register with the
OfficeServ 12 system. This entry can be alphanumeric. Default is ‘1234’.
02 IP ADDR This is the IP address of the IP phone once registered with the system.
This is read only data. Default is 0.0.0.0.
03 MAC ADDR This is MAC address of the IP phone once registered with the system.
This is read only data. Default is FFFFFFFFFFFF.
04 SIG PORT This is the IP UDP port of the IP phone once registered with the system.
This is read only data. This information will be needed when traversing NAT
routers, firewalls, etc. Default is 6000.
05 VOICE PORT This is the IP RTP port of the IP phone once registered with the system.
This is read only data. This information will be needed when traversing NAT
routers, firewalls, etc. Default is 9000.
06 IP TYPE This is the type of IP network used : PRIVATE or PUBLIC. Default is
PRIVATE.
07 DSP TYPE This selects which CODEC this phone’s DSP will use. G.729A(low bandwidth)
or G.711(high bandwidth). This data uses IP phone to IP phone connection
only, others case are follow MGI CODEC type. Default is G.729A.
08 PHONE TYPE This the type of IP phone used. SAMSUNG or SIP(future). Please should
be use SAMSUNG.
09 REGIST CLR This is used to clear the registration of a particular IP phone. This is similar
to phone plug out and plug in, and the useful for maintenance. Because
technician will be re-registered IP phone without network cable find out first.
10 FRAME
COUNT
This value determines the transmission interval time of VoIP packets
generated by the IP phone. This data uses case of MMC 841 ITP DSP
PARA DOWN=PHONE DATA only. The range is 10-40ms. Default is 10ms.
11 JITTER SIZE Decides the minimum time to consider delay for jitter adjustment. This data
uses case of MMC 841 ITP DSP PARA DOWN=PHONE DATA only.
The range is 10-90ms. Default is 20ms.