Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming
© SAMSUNG Electronics Co., Ltd. Page 2-331
845 WLAN Para
This MMC modifies the WLAN parameter.
Set the network configuration with the WLAN parameters, which are the SYSTEM
ID, the System KEY, and the WBS24 and SIP related with WLAN call.
The system KEY is used internally to distinguish between systems when registering a
terminal. The default value is ‘00000’, but only when this value is modified to
another value, an electric power will be supplied to the WBS24, thus enabling the use
of the WLAN terminal, In addition, the System KEY serves as an identification ID
when the WLAN terminal connects to the WBS24.
The default value of the SYSTEM ID, ‘WBS24’, must be modified to another value
in order to use a multiple system in one area. The DNS setting for WLAN is
additionally described in this menu.
Set the network configuration for WBS24 by setting the IP assignment, Netmask, and
Gateway. These settings should be compatible with the Intranet since the network
configuration setting is essential for data service. In addition, the RF frequency for
WBS24 should be selected. Currently up to 14 frequencies may be selected.
Session Initiation Protocol(SIP) variables used for the WBS24(Basic) can be defined.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
ACTION
PROCEDURE DISPLAY
1. Press the Transfer button, and enter 845.
WLAN : SYSTEM ID
0000
845: WLAN PARA
SELECT PROG ID
2. Press the Speaker button to enter the select menu.
When the cursor is at WLAN, press the
WLAN: SYSTEM ID
WBS24
[UP & DOWN] button and select
WLAN, WBS, or SIP.
3. Press the Soft button and move to the SYSTEM
ID. When the cursor is below SYSTEM ID,
WLAN: SYSTEM ID
WBS24