Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

105 Station Speed Dial

Allows the system administrator or technician to program the personal speed dial

locations assigned to a station. This must be done for single line telephones because

these stations cannot access programming. Each station may have up to 50 locations

or bins assigned to it in MMC 606 Assign Speed Block. The speed dial bins are

numbered 00-49. Each speed dial number consists of a trunk or trunk group access

code followed by a separator and up to 24 digits to be dial. These dial digits may

consist of 0-9, * and #. If the system recognizes a valid trunk or trunk group access

number, it will automatically insert the separator.

PROGRAM BUTTONS

VOLUME Used to scroll through options

KEYPAD Used to enter selections

SOFT Move cursor left and right

SPEAKER Used to advance next MMC

HOLD Used to clear previous entry

B Used to insert a flash code ‘F’

C Used to insert a pause code ‘P’

D Used to insert a pulse/tone conversion code ‘C’

E Used to mask/unmask following digits(shows as ‘[’ or ‘]’)

F Used to enter name for speed dial bin(see MMC 106)

ACTION

PROCEDURE DISPLAY

1. Press Transfer button and enter 105

Display shows

[201] SPEED DIAL

00:

2. Dial station number(e.g., 205)

[205] SPEED DIAL

00:

Press Volume button to select station and press

Right Soft button to move cursor

If selected station has no speed dial bins, the

display will be as shown and a new station may

[205] SPEED DIAL

SPDBLK NOT EXIST

be selected

3. Dial location number(e.g., 05)

[205] SPEED DIAL

05:_

Press Volume button to select location and press

Right Soft button to move cursor