Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-32 © SAMSUNG Electronics Co., Ltd.
116 Alarm And Message
Allows the system administrator or technician to set or change the alarm
clock/appointment reminder feature for any station. This must be done for single line
telephones because they cannot access programming. Three alarms may be set for
each station and each alarm may be defined as a one-time or TODAY alarm or as a
DAILY alarm, as described below : The TODAY alarm is automatically cancelled
after it rings, while the DAILY alarm rings every day at the same time. It is also
possible to set a message to display when the alarm is sounded.
No Alarm Mode Description
0 NOTSET No alarm
1 TODAY Alarm only once
2 DAILY Alarm daily at set time
Names are written using the keypad. Each key press selects a character. Pressing the
dial keypad key moves the cursor to the next position. For example, if the message is
‘SAM SMITH, ’ press the number ‘7’ four times to get the letter ‘S’. Now press the
number ‘2’ once to get the letter ‘A’. Continue selecting characters from the table
below to complete your message. Pressing the bottom left programmable button will
change the letter from upper case to lower case.
When the character you want appears on the same dial keypad key as the previous
character, press the Volume Up button to move the cursor to the right.
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V * 8
DIAL 9 W X Y Z 9
DIAL * : = [ ] *
The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,
%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",
"
,` , and \.