Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

117 Edit Text Message

Allows the system administrator or technician to set or change text message for any

station. One station can use up to 10 text messages.

In MMC 611 Text Message Station set USED station only uses this feature.

Messages are written using the keypad. Each key press selects a character. Pressing

the dial keypad key moves the cursor to the next position. For example, if the

message is ‘SAME TIME’, press the number ‘7’ four times to get the letter ‘S’. Now

press the number ‘2’ once to get the letter ‘A’. Continue selecting characters from the

table below to complete your message. Pressing the bottom left programmable button

will change the letter from upper case to lower case.

When the character you want appears on the same dial keypad key as the previous

character, press the Volume Up button to move the cursor to the right.

Count 1 2 3 4 5

DIAL 0 < > . ) 0

DIAL 1 Space ? , ! 1

DIAL 2 A B C @ 2

DIAL 3 D E F # 3

DIAL 4 G H I $ 4

DIAL 5 J K L % 5

DIAL 6 M N O ^ 6

DIAL 7 P Q R S 7

DIAL 8 T U V * 8

DIAL 9 W X Y Z 9

DIAL * : = [ ] *

The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,

%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",

,` , and \.