Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

118 Conference Group

Allows the system administrator or technician to set one touch conference group

using GCONF key for any station. One station can use up to 6 conference groups,

and each group can be set 5 member.

In MMC 612 Conference Group Station set USED station only uses this feature.

On conference member, allows both internal station or station group number and

outgoing access code plus external telephone number.

Conference group names are written using the keypad. Each key press selects a

character. Pressing the dial keypad key moves the cursor to the next position.

For example, if the group name is ‘SAMSUNG’, press the number ‘7’ four times to

get the letter ‘S’. Now press the number ‘2’ once to get the letter ‘A’. Continue

selecting characters from the table below to complete your message. Pressing the

bottom left programmable button will change the letter from upper case to lower

case.

When the character you want appears on the same dial keypad key as the previous

character, press the Volume Up button to move the cursor to the right.

Count 1 2 3 4 5

DIAL 0 < > . ) 0

DIAL 1 Space ? , ! 1

DIAL 2 A B C @ 2

DIAL 3 D E F # 3

DIAL 4 G H I $ 4

DIAL 5 J K L % 5

DIAL 6 M N O ^ 6

DIAL 7 P Q R S 7

DIAL 8 T U V * 8

DIAL 9 W X Y Z 9

DIAL * : = [ ] *

The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,

%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ; ,",

,` , and \.