Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-46 © SAMSUNG Electronics Co., Ltd.
200 Open Customer Programming
Used to open(enable) and close(disable) customer-level programming.
If programming is not opened and an attempt is made to access a system MMC,
the error message [NOT PERMIT] will be displayed. A four digits passcode is
required to access this MMC. Each digit can be 0-9. When opened, this MMC
enables access to all MMCs allowed in MMC 802 Customer Access MMC Number.
PROGRAM BUTTONS
!
VOLUME Select open or closed
!
KEYPAD Used to enter passcode
!
SPEAKER Save data and advance to next MMC
!
TRANSFER Exit Programming
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 200
Display shows
ENABLE CUS.PROG.
PASSCODE:
2. Enter passcode
ENABLE CUS.PROG.
PASSCODE:
Correct code shows
ENABLE CUS.PROG.
DISABLE
Incorrect code shows
ENABLE CUS.PROG.
PASSCODE ERROR
3. Press Volume button arrow key to select ENABLE
OR
ENABLE CUS.PROG.
ENABLE
DISABLE and press Right Soft button OR
Dial 1 for ENABLE or 0 for DISABLE
4. Press Speaker button to advance MMC entry
level and press Volume button to select MMC
201:CUS.PASSCODE
SELECT PROG. ID
OR
Enter MMC number and press Right Soft button
to enter MMC
5. Press Transfer button to exit