Installation manual

CHAPTER 2. Hardware of OfficeServ 7030

Checking MEM LED before power off

Don’t turn off the power whilst the MEM LED is blinking. It may cause a

malfunction of the system. If you want to turn off power, turn off power switch after

dismounting MEM with ‘KMMC 817 MEM UMOUNT’.

Checking LAN cable during lighting LAN LED on

LAN LED lights on when an EPM board is installed LAN cable is not connected.

Check if LAN cable is connected during lighting LAN LED on.

Figure 2.3 Right side view of OfficeServ 7030 cabinet

The descriptions about each part on the right of the cabinet are listed in the table below.

Table 2.3 Parts on the right panel of the cabinet

Part Function

C.O 1-4 Trunk ports

LINK1-3 Ports that connect the Base cabinet with the expansion cabinet

EXT1-8 Station ports for subscribers (ex. analog phone, digital phone, LAN)

Reset Button for resetting the system

SLT1, 2 Station ports for analog phones

MISC Ports that connect external music sources, paging device, loud bell,

common bell, or door bell

LAN LAN port