Installation guide

CHAPTER 2. MMC Programming OfficServ 7400 Programming Guide
Samsung Business Communications
2-115
[416] ASSIGN E&M/DID RINGDOWN
This MMC defines which ring destination table an E&M or DID trunk will follow
for incoming calls. There are three options for each trunk as defined below.
No Option Description
0 FOLLOW INCOM DGT When a trunk is set to this option, calls will ring at the destina-
tion that matches the digits received from the Trunk line.
1 FOLLOW DID TRANS When a trunk is set to this option, calls will ring at the destina-
tion defined in MMC 714 that matches the digits received from
the TRUNK LINE.
2 FOLLOW TRK RING If this option is selected, press the Right Soft button and ‘NO.
RCV DIGIT’ will appear on the display. Here is where the num-
ber of incoming digits from Trunk Line must be entered (0-4).
When a trunk is set to this option, calls will ring at the destina-
tion defined in MMC 406 for that trunk. If the destination de-
fined in MMC 406 is a VMAA port or group then the system will
repeat the digits received from the CO to the port when it an-
swers.
CONDITIONS
R2MFC trunk lines only support the ‘FOLLOW INCOM DGT’ and ‘FOLLOW DID
TRANS’ options.
DEFAULT DATA
FOLLOW INCOMING DIGIT
ACTION DISPLAY
1. Press Transfer button and enter 416.
Display shows:
[701] EM/DD RING
FOLLOW INCOM DGT
2. Enter desired trunk number (e.g., 705)
OR
[705] EM/DD RING
FOLLOW INCOM DGT
Press Volume button to make selection and
press Right Soft button to move cursor.
OR
Select all trunks.
[ALL] EM/DD RING
FOLLOW INCOM DGT
3. Dial option number (0~2)
OR.
[705] EM/DD RING
NO. RCV DIGIT:00
Press Volume button to make selection and press
Right Soft button to return step 2.
If FOLLOW TRK RING is selected, the
LCD display shows step 4.