Installation guide

CHAPTER 2. MMC Programming OfficServ 7400 Programming Guide
Samsung Business Communications
2-2
Programming Procedures
This section describes the procedure for each MMC.
[100] STATION LOCK
Allows the system administrator or technician to lock or unlock an individual station or all
stations simultaneously. The three options are as follows:
No Type Description
0 UNLOCKED Unlocks a locked station.
1 LOCKED OUT The phone cannot make calls outside the system. It can however make
and receive intercom calls and receive incoming Trunk Line calls. When
in this mode the Hold button will flash slow RED.
2 LOCKED ALL The phone cannot make or receive any calls. When in this mode the
Hold button will light steady RED.
CONDITIONS
Check if the station lock function is disabled in MMC 301, ASSIGN STATION COS. If so,
the station cannot be locked, but a locked station can be unlocked.
DEFAULT DATA
ALL STATIONS UNLOCKED
ACTION DISPLAY
1. Press Transfer button and enter 100.
Display shows:
[201] STN LOCK
UNLOCKED
2. Dial station number (e.g., 205)
OR
[205] STN LOCK
UNLOCKED
Press Volume button to select station and
press Right Soft button to move cursor.
OR
Select all stations.
[ALL] STN LOCK
?
3. Enter 0 to unlock or 1 to lock (e.g., 1)
OR
[205] STN LOCK
LOCKED OUT
Press Volume button to make selection and
press Right Soft button to return to step 2.