Operating instructions

1716
4
Remove four small screws from the rear side of the display, than separate the
stand from the PDP.
5
Remove four large screws from the rear side of the display.
6
Insert the bolts and insulation holders into the four screw-holes as shown in the
following figure:
ΠBolt
´ Insulation holder
7
Hang the protruding plastic part on the rear of the PDP in the groove on the
top of the wall attachment panel. Then, slide down the PDP. (Do not slide
down the PDP with too much force. The protruding plastic part might be taken
off.)
´
Œ
Separating the Display from the Wall Attachment Panel
´
Œ