User Manual
Table Of Contents
- overview
- outdoor vandal dome camera
- indoor dome camera
- flush mount dome camera
- outdoor bullet camera
- box camera
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
14_ outdoor vandal dome camera
outdoor vandal dome camera
4. Join the mount plate with the camera case.
x4
2x
TR20
Installing the camera module
1. Connect the network/power/audio/alarm cables to the camera module terminal.
2. Attach the camera module to the case.
J
`
A magnet is embedded at the bottom of the module
`
Take caution not to allow any foreign objects between the attaching surfaces.
3. Adjust the lens to the desired direction with reference to “Adjusting the monitoring direction for the
camera” section. (page 41)