User Manual
Table Of Contents
- overview
- outdoor vandal dome camera
- indoor dome camera
- flush mount dome camera
- outdoor bullet camera
- box camera
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
22_ indoor dome camera
indoor dome camera
Installing the camera module
1. Connect the network/power/audio/alarm cables to the camera module terminal.
2. Attach the camera module to the case.
J
`
A magnet is embedded at the bottom of the module
`
Take caution not to allow any foreign objects between the attaching surfaces.
3. Connect the microphone cable to the camera module.
4. Adjust the lens to the desired direction with reference to “Adjusting the monitoring direction for the
camera” section. (page 41)
[Installing audio/alarm cables]
3-1. Mount the cable bushing of the provided audio/alarm cables to the camera case.
4. Join the mount plate with the camera case.
x4
2x
TR20