User Manual

English - 24
Changing the Format
Select the optimal input format to match your graphic cards or 3D
software.
See the descriptions for Steps 1 to 4 above.
5 Press the ▲ or ▼ button to select Format, then press the
ENTER button.
6 Press the ▲ or ▼ button to select Checker Board, Horizontal
or Vertical then press the ENTER button.
Checker Board
If the output format of your graphic card or 3D
software is Checkerboard, select this input
format.
Horizontal
If the output format of your graphic card or 3D
software is Horizontal interleaved, select this input
format.
Vertical
If the output format of your graphic card or 3D
software is Vertical interleaved, select this input
format.
➢
You can press the 3D button on the remote control
repeatedly to change the 3D mode.
Easy Setting
1 Press the
TOOLS button on the remote control.
2 Press the ◄ or ► button to select 3D Mode
.
3 Press the
ENTER button to start the 3D Effect.
Resetting the Picture Settings to the Factory Defaults
You can set detailed picture settings.
1 Press the MENU button to display the menu.
2 Press the ENTER button to select Picture.
3 Press the ▲ or ▼ button to select Reset, then press the
ENTER button.
4 Press the ▲ or ▼ button to select OK or Cancel then press
the ENTER button.
 ➢
Each mode can be reset.
Move Enter Return
Mode : Mode 1
Format :
3D Effect
T V
Checker Board
Horizontal
Vertical
Tools
3DEffect ◄ Off ►
Anynet+ (HDMI-CEC)
Picture Mode : Dynamic
Sound Mode : Standard
Sleep Timer : Off
SRS TS XT : Off
Energy Saving : Off
Adjust
ExitMove
Move Enter Return
Mode : Standard
Cell Light 7
Contrast 95
Brightness 45
Sharpness 50
Colour 50
Tint G50 R50
Detailed Settings
Picture Options
Reset : OK
Picture
T V
OK
Cancel
BN68-01528B-Eng.indb 24 2008-06-03 오후 1:35:52