Quick Start Guide

English - 27

Installing batteries (Battery size : AA)

1. Press the back of the remote at the very bottom with both thumbs, and then slide the battery cover up

in the direction of the arrow.

2. Install two batteries so that the polarity of the batteries (+/-) matches the illustration in the battery

compartment.

3. Slide the cover down in the direction of the arrow to close the battery cover.

Initial Pairing

TV STB BD

RETURN VOICE NUMBER

TV STB BD

RETURN VOICE NUMBER

30cm ~ 4m

IR receiver

• Smart Touch Control

After you have run the Initial Setup on your TV, you should connect your Smart Touch Control to your TV.

1. Point the Smart Touch remote control toward the IR Sensor of the TV and press any key on the Smart

Touch remote control.

2. The connection icons appear on the bottom left of the screen, and the TV connects to your Smart

Touch Control automatically.

✎

If you want to perform the pairing process again, press the reset button in the centre of the back

cover using a pin or the tip of an unbent paper clip. The Smart Touch Control will be initialized.

• Smart Touch Control PAIRING Reset button

Calibrating the Touch Pad

To calibrate the Touch Pad on the Smart Touch Control, follow these steps:

1. Press the NUMBERš button for 3 seconds. The calibration starts.

2. When done, all the LEDs on the top of the Smart Touch Control blink twice simultaneously.

✎

While calibrating, don't touch the Touch Pad.

✎

If the Touch Pad loses accuracy, re-calibrate the Touch Pad by repeating Steps 1 and 2.

[PE8000-XU]BN68-04062J.indb 27 2012-04-03  5:29:10