User Manual
English - 7
01 TV Installation
Invisible Connection Guide
ONE CONNECT
One connect
Bending Cover
To connect the Invisible Connection cable to the One Connect and your TV, take the following steps:
1. Read all the instructions below before you begin.
2. Carefully remove the Invisible Connector from its Styrofoam protector.
3. Carefully unwind the cable (with the
icon) from the cable holder of the Invisible Connection. Unwind enough
cable to make the connection between the TV and the One Connect Box.
– If you unwind the cable (with the
icon) from the cable holder, the cable may be entangled or damaged.
[ DO NOT bend the One Connect ber optical cable. Especially, do not bend the cable at a right angle. You can damage or
break the cable. The TV will not work if the cable is broken or damaged.
4. Connect the connector with the icon to the TV, and then connect the connector with the icon to the One
Connect as shown in the illustration above.
5. Connect the One Connect AC power cord to the One Connect and to a power outlet as shown in the illustration
above.
•
Connection from being bent at a 90 degree angle. Failure to do so may cause damage to the cable.
•
connected correctly. Failure to do so may cause product malfunction.
• After connecting the Invisible Connection, wind the remaining cable around the cable holder of the
Invisible Connection. Just winding or leaving the remaining cable as it is may cause damage to the cable.
•
Failure to do so may cause performance degradation to the TV or damage to the cable.
• To prevent the Invisible Connection from being damaged, do not subject the Connection to the following:
Bending Twisting Pulling Stepping on Pressing on
CLASS 1 LASER PRODUCT
• Caution - Invisible laser radiation when open. Do not stare into beam.
– Do not bend or cut cables excessively.
– Do not place heavy objects on the cable.
– Do not disassemble the connector of the cable.
•
herein may result in hazardous radiation exposure.