User Manual

English _19
! INSTALLATION & CONNECTION
5. Close the dome cover.
`
Securely fasten the fastening bolt using an Torx L wrench to prevent water
from leaking.
Connecting the LAN cable
1. Remove the dome cover and the case.
2. Pull off the cable bush at the bottom as shown in the figure.
J
`
Use an appropriate cable bush for the LAN cable to be connected.
- Basic camera : Use the cable with a diameter of Ø5~6.5.
3. Pull off the extruded part of the 1-hole cable bush provided.
4. Use the cap installer to route the LAN cable through the
cable bush.
5. Route the LAN cable through the hole created after removing the cable
bush in Step 2, and then connect it to the ethernet terminal.
6. Insert the bush of the LAN cable into the hole.
Connecting the audio/alarm cable and power cable
1. Remove the dome cover and the case.
2. Pull off the cable bush at the bottom as shown in the figure.
3. Pull off the small extruded part on the bush of the alarm/audio cable,
and route the power cable through the bush.
4. Route the alarm/audio cable through the hole left after removing the
cable bush in Step 2. Connect each to the alarm/audio terminal and
power terminal block of the PCB, respectively.
5. When mounting the camera, hang the cables on the fixed hook to avoid
cables from being damaged or pinched.
6. Insert the bush of the alarm/audio cables into the hole.
7. Adjust the lens in a desired direction by referring to the “Adjusting the
monitoring direction for the camera” section.
(page 23)
8. Attach the dome cover.
1 2 3
4 5 GND
RESET
VIDEO
3.AUDIO IN
2.ALM OUT
1.ALM IN
NETWORK
ACT LINK
CAUTIO N: Be ware o f the
Rated Voltage and Polari ty
of the power conn ection .
1 2 3
4 5 GND
RESET
VIDEO
3.AUDIO IN
2.ALM OUT
1.ALM IN
NETWORK
ACT LINK
DC12V
3.AUDIO IN
2.ALM OUT
.ALM IN
VIDEO
1 2 3
4 5 GND
RESET