User Manual
Table Of Contents
- overview
- Important Safety Instructions
- Recommended PC Specifications
- Recommended Micro SD/SDHC/SDXC Memory Card Specifications
- NAS recommended specs
- What’s Included
- At a Glance (QND-7012R/7022R/7032R)
- At a Glance (QND-7082R)
- At a Glance (QNO-6014R/7012R/7022R/7032R/6084R/7082R)
- At a Glance (QNV-6014R/7012R/7022R/7032R)
- At a Glance (QNV-6084R/7082R)
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
installation & connection
28_ installation & connection
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding power port of the
camera.
J
`
If both PoE and DC 12V are applied simultaneously, the product will be supplied with power from DC 12V.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
- It is advisable to use only one power source from PoE and DC 12V.
`
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
Power Cable Specification for Each Model
In case of DC 12V Input:
Wire Type (AWG) #22 #20 #18
Cable Length (Max.) 10m 16m 26m
Network Cable Specification
Item Contents Remark
Connector RJ45
Ethernet 10/100BASE-T 10/100 Mbps
Cable Category 5e
Max Distance 100M DC Resistance ≤ 0.125 Ω/m
PoE Support IEEE 802.3af
J
`
If you use a cable other than Category 5e standards, 100m of transmission distance is not guaranteed.
Connecting to Audio Input
1. Connect the AUDIO IN port of the camera with the microphone or LINE OUT port.
M
`
The QND model supports the built-in microphone only.
2. Check the specifications for audio input.
~
Audio Codec
- Audio In : G.711 PCM (Bit Rate: 64kbps / Sampling Frequency: 8kHz), G.726 ADPCM (Bit Rate:
16Kbps, 24Kbps, 32Kbps, 40Kbps / Sampling Frequency: 8kHz)
~
Full duplex Audio
~
Audio in (QND-7012R/7022R/7032R/7082R) : Built-in microphone
~
Audio in (QNO-6014R/7012R/7022R/7032R/6084R/7082R, QNV-6014R/7012R/7022R/7032R/6084R/
7082R) : Selectable (microphone/Line-in), Supported voltage: 2.5VDC (4mA), Input impedance: 2K Ohm
Network
Speaker
Microphone
Microphone
Microphone
Amp
Amp
PC
Microphone