Quick Guide 2021.03.11

ENGLISH
After completing each step, check the box
For questions, contact 1-800-SAMSUNG (726-7864)
1. Check if the
entrance is wider
than 32 1/4”
Check
Check
2. If Entrance is less than 32 1/4” wide, remove the Doors.
Reassemble in reverse order. Be sure to reattach and tighten all bolts.
FREEZERFRESH FOOD
A
B
C
B
A
3. Water Installation
*
Make sure water
does not leak.
Check
4. Connect
Power
Check
5. Level unit
Check
6. Door Alignment
Make sure doors are properly aligned
Check
Two fastener-rings are enclosed with the refrigerator.
Control LeverControl Lever
Screwdriver
A
B C
*
*
8. Set Temperatures
Check
Recommended setting
· Freezer : 0 °F
· Fridge : 37 °F
7. Make sure the fridge is not in cooling off mode
Check
Cooling Off Mode
When “0, FF” is shown on the display
To cancel the cooling off mode, press and hold
( ) and ( ) together for 6 seconds and then
press ( ) once the display blinks.
Refer to User Manual for more information.
Take out the lower basket( ) by lifting the
basket from rail system.
Remove four 10mm hex-head bolts from both
sides.
Lift the freezer door up from the rails.
Remove 3 screws
Remove 10mm
Hex head bolts
Remove screw
Cartridge
Holder
Clip
Filter cartridge
Plastic line
(Provided)
See grounding information attached to
power cord.
Lower support legs to touch the
floor. If unit be moved, raise the
support legs before moving the unit.
When you turn the
5/32inch Allen wrench
counterclockwise
( ), the door will
move up.
After adjusting the doors, please insert the supplied
fastener-ring ( ) using a pair of pliers ( ) in the
gap between the hinge-grommet ( ) and the lower
hinge( ). The number of the fastener-ring to insert
depends on the gap.
C
Lift the door up to remove
Door removal for entrance / Extracción de la puerta para la entrada /
Retrait de la porte pour le passage de la porte d’entrée
[EN] Depending on the model that was purchased, the door disassembly procedure, shape of parts and number of screws may differ.
Instructions for disassembling and assembling the door are explained in detail in the instruction manual supplied with the product.
Before Installing, must measure refrigerator depth & house door width. In case of clearance less than 4 inches, must detach doors from
Unit and move it into the house.
[ES] Dependiendo del modelo adquirido, puede variar el procedimiento de desensamble de la puerta, la forma de las piezas y el
número de tornillos. En el manual de instrucciones provisto con el producto se ofrecen indicaciones detalladas para ensamblar y
desensamblar la puerta. Antes de la instalación debe medir la profundidad del refrigerador y el ancho de la puerta de la casa.
En caso de que el espacio libre sea inferior a 4 pulgadas, debe retirar las puertas de la unidad antes de llevarla dentro de la casa.
[FR] En fonction du modèle acheté, la procédure de démontage de la porte, la forme des pièces et le nombre de vis peuvent varier.
Les instructions de démontage et d’assemblage de la porte sont expliquées en détail dans le manuel d’utilisation fourni avec l’appareil.
Avant de procéder à l’installation, vous devez mesurer la profondeur du réfrigérateur et la largeur des portes de votre maison.
Dans le cas d’un dégagement de moins de 4 pouces, vous devez démonter les portes de l’appareil pour pouvoir le faire rentrer dans
votre maison.
Detach the fridge doors / Retirar las puertas del refrigerador / Démonter les portes du réfrigérateur
A
B
C
Detach the freezer drawer / Retirar el cajón del congelador / Démonter le tiroir du congélateur
DA68-01853B-00
DA68-01853B-00.indd 1 2020. 11. 17. 오전 11:38