User Manual
Table Of Contents
- FDR_RF8000MC_DA68-03563D-05_EN
- Safety information
- What you need to know about the safety instructions
- Important safety symbols and precautions:
- State of California Proposition 65 Warning
- Important safety precautions
- Severe warning signs for transportation and site
- Critical installation warnings
- Installation cautions
- Critical usage warnings
- Usage cautions
- Cleaning cautions
- Critical disposal warnings
- Installation
- Operations
- Maintenance
- Troubleshooting
- LIMITED WARRANTY (U.S.A.)
- Regulatory Notice
- Safety information
- FDR_RF8000MC_DA68-03563D-05_MES
- Información sobre seguridad
- Qué debe saber sobre las instrucciones de seguridad
- Símbolos y advertencias de seguridad importantes:
- Advertencia sobre la State of California Proposition 65
- Precauciones importantes de seguridad
- Señales de advertencia importantes para el transporte y el emplazamiento
- Advertencias muy importantes para la instalación
- Precauciones para la instalación
- Advertencias muy importantes para el uso
- Precauciones de uso
- Precauciones para la limpieza
- Advertencias muy importantes para la eliminación de residuos
- Instalación
- Funcionamiento
- Mantenimiento
- Solución de problemas
- GARANTÍA LIMITADA (EE.UU.)
- Aviso regulatorio
- Información sobre seguridad
Maintenance
English68
Maintenance
3. Insert a new lter cartridge. Use only
Samsung-provided or approved lters.
4. Turn the cartridge knob clockwise to
lock into place.
5. On the Home screen, tap Fridge
Manager > Fridge Settings > Water
Filter, and then select RESET. The lter
indicator turns off.
6. When you are done replacing the lter,
open the water valve and run water
through the dispenser for about 7
minutes. This is to remove impurities
and air from the water line.
NOTE
• A newly installed lter may cause the water dispenser to spurt water briey. This is
because air has entered the waterline.
• The replacement process may cause the water dispenser to drip for a short period of
time. If it drips, simply wipe up any water on the oor with a dry towel.
Reverse osmosis water ltration system
The water pressure of the water supply system to a reverse osmosis water ltration
system must be between 35 psi and 120 psi (241 kPa and 827 kPa).
The water pressure of the reverse osmosis water ltration system to the refrigerator’s
cold water line must be at least 40 psi (276 kPa). If the water pressure is below these
specications:
• Check if the sediment lter in the reverse osmosis system is blocked. Replace the lter
if necessary.
• Rell the water tank in the reverse osmosis system with water.
• If your refrigerator has a water lter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water lter.
For more information or servicing, contact a licensed plumbing professional.
Untitled-1 68 2020-04-09 AM 10:49:15