User Manual

English 41
Operations
Autoll Pitcher
Press and hold Fridge for 3 seconds to turn this function on. Open
the left door of the fridge, and then insert the water pitcher. Close
the door and the water pitcher will be lled with water up to the
preset level.
To turn the function off, press and hold Fridge again for
3 seconds.
NOTE
• By default, Autoll Pitcher is disabled. Enable this function
after you have installed the water line.
• If you open the door or push the dispenser lever, this function
is stopped temporarily.
• The Autoll Pitcher indicators blink if there is a leak. This may
occur because the water pitcher overows, or the water-line or
water-level sensor fails. If this is the case, follow these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system
failure. Contact a local service center.
FDR_AW2-FS_DA68-03873A-00_EN.indd 41 2019-05-17  10:23:30