User Manual

English - 21
02 OPERATING
3
2
3. Insert the new filter into the filter case ( 4 ).
4
4. Push the filter, and then turn it clockwise until
it locks.
• If you have trouble inserting the water
filter because of high water pressure,
shut o the water supply valve.
The locked symbol should be lined up with the
indicator line.
5. Touch and hold the Alarm / hold 3 sec for
Filter Reset” button (
(Filter Reset)
) for about 3
seconds to reset the water filter indicator. The
indicator’s red light will turn o.
6. If you turned o the water supply, turn it back
on.
For a replacement water filter, visit your
local home Improvement center or visit
Samsung’s parts distributor on line at:
http://www.samsungparts.com
Be sure the replacement water filter has
the SAMSUNG logo on the box and on the
water filter.
Removing any residual matter inside
the water supply line after installing
the water filter.
1. Turn ON the main water supply and supply
water from water supply line.
2. Run water through the dispenser until the
water runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3. Additional flushing may
be required in some
households.
4. Open the Refrigerator
door and make sure
there are no water
leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis
system is less than 40 to 60 psi (276 to 414 kPa):
Check if the sediment filter in the reverse
osmosis system is blocked. Replace the filter
if necessary.
Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
DA68-02952A-11.indb 21 2018. 7. 9. �� 5:18