User Manual

Operations
English42
Operations
Filter Reset
After about 6 months (and typically, about 300 gallons (1200 L) of
water), the Filter indicator blinks red for several seconds when you
open the door, reminding you that the lter needs to be replaced.
When this happens, replace the lter, and then press and hold Filter
Reset for 3 seconds. The lter lifecycle will be reset and the Filter
indicator turns off.
NOTE
• Some regions have relatively large amounts of lime in their water.
This can reduce the lifecycle of the lter. In these areas, you will
have to replace the water lter more often than specied above.
• If water is not dispensing properly, the water lter is most likely
clogged. Replace the water lter.
05 Water/Ice / Dispenser Lock (3 sec)
Water/Ice
You can dispense chilled water, cubed ice, or crushed ice. To dispense,
press Water/Ice. The corresponding indicator turns on.
Dispenser Lock
(Dispenser
panel /
Dispenser
lever)
To prevent use of the dispenser panel buttons and the dispenser lever,
press and hold Water/Ice for more than 3 seconds.
If you press and hold the button again for more than 3 seconds, the
dispenser lock will be deactivated.
NOTE
• The Dispenser Lock on the dispenser panel does not affect the
controls on the main panel. To lock the main panel, use the Control
Lock function on the main panel.
• If you press Water/Ice for 3 seconds when both control lock and
dispenser lock are active, you will deactivate both control lock and
dispenser lock.
06 Network connection
You can control and monitor your refrigerator on the SmartThings app. For more
information, see the SmartThings section.
Untitled-1 42 2021-05-21  4:47:17