Owner manual

9
7
8
12
10
11
3. Remove the 3 hex head bolts
7
attached
to the upper left and right door hinges with a
wrench (10 mm). With a Philips head screwdriver,
remove the ground screw
8
attached to the
upper left and right door hinges. Remove the
upper left and right door hinges
9
.
4. Lift the door straight up to remove.
5. With a Philips head screwdriver, remove the
two screws
10
attached to the lower left and
right door hinges. With an wrench (5 mm),
remove the two hex head bolts
11
attached to
the lower left and right door hinges. Remove
the lower left and right door hinges
12
.
REATTACHING THE
REFRIGERATOR DOORS
To reattach the fridge doors, assemble parts in
reverse order.
1. The Water Line must be fully inserted to the
center of transparent coupler (Type A) or the
Guide Lines (Type B) to prevent water leakage
from the dispenser.
2. Insert the clip in the install pack and check that
it holds the line fi rmly.
DISASSEMBLE THE FREEZER DRAWER
1. Push the upper drawer in completely.
2. Remove the tilting pocket
1
by pulling on both
brackets
2
upward at the same time.
3. Take out the lower basket
3
by lifting the
basket up from rail system.
4.
Remove four 10 mm hex-head bolts from both sides.
5. Lift the freezer door up from the rails.
Putting too much food into the freezer
drawers can prevent the freezer from closing
completely and can cause frost build-up.
Center of Transparent coupler
Center of Transparent coupler
The Guide Lines
The Guide Lines
Dispenser
Dispenser
clip A (1/4”)
clip A (1/4”)
(6.35 mm)
(6.35 mm)
clip A (1/4”)
clip A (1/4”)
(6.35 mm)
(6.35 mm)
Type A
Type A
Type B
Type B
16_ Setting up
Slot
3
1
2
CAUTION
DA99-03403B-10.indb 16DA99-03403B-10.indb 16 2014. 7. 18.  8:012014. 7. 18.  8:01