Product manual

English - 10

When moving your refrigerator

To prevent ﬂ oor damage, be sure the front levelling

legs are in the up position (above the ﬂ oor).

See “Leveling the Refrigerator” on page 14 for

instructions.

Screw DriverLeg

Flooring

For proper installation, you must place this

refrigerator on a level, hard surface that is the

same height as the rest of the ﬂ oor.

This surface should be strong enough to support a

fully loaded refrigerator.

To protect the ﬁ nish of the ﬂ ooring, cut a large

section of the cardboard carton and place it under

the refrigerator where you are working.

When moving the refrigerator, you need to pull and

push it straight forwards or back.

Do not wiggle it from side to side.

Required Tools (Not provided)

Philips

screwdriver (+)

Flat-blade screw

driver (-)

Socket wrench

(13/32”) (10mm)

Allen wrench

(3/16”) (5mm)

REMOVING THE REFRIGERATOR

DOORS

If your entrance won’t allow the refrigerator to pass

easily through it, you can remove the doors.

To remove the doors, follow the steps starting

below.

If you do not need to remove the doors, go to

“Leveling the Refrigerator” on page 14.

1. SEPARATE THE WATER SUPPLY LINES

FROM THE FRIDGE

1. Pull the two water lines (which are in the Fixer)

out to the front.

DA68-03178A-03.indb 10DA68-03178A-03.indb 10 2015. 1. 26.  11:582015. 1. 26.  11:58