Product manual

English - 19
SETTING UP
COMPLETING THE SET UP
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
2. Once the refrigerator is plugged in, make sure
the interior light turns on when you open the
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly.
Reset the refrigerator and freezer to the
temperatures you want.
4. After you plug the refrigerator in, it will
take a few hours to reach the appropriate
temperature.
You can store food and drinks in the refrigerator
after the temperature is suffi ciently cool.
5. Once installation is complete, press the
dispenser lever to check if the water or the ice
is properly dispensed.
6. Make sure the front side of the refrigerator is
0.6 degree higher than its rear side.
If condensation or water drops appear on
dispenser surrounding (a) and partition
between freezer and refrigerator (b), turn
the Energy Saver mode off after removing
the condensation.
(See the explanation of the Energy Saver
button in “Using the Control Panel” on
page 20.)
(a)
(a)
(b)
(b)
DA68-03178A-03.indb 19DA68-03178A-03.indb 19 2015. 1. 26.  11:582015. 1. 26.  11:58