User manual

12_ setting up
Change the positions of the Handle slider and 3.
spring from the left side to the right side.
Make sure to change position of the Handle slider
cap from the right side to the left side.
Assemble the door handle by following step 2 4.
and 1 in reverse order.
This procedure must be done before
‘Reversing the Refrigerator Door’ step 23.
LEVELLING THE
REFRIGERATOR
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
Turn the adjusting legs clockwise to raise and
counter-clockwise to lower the height.
Case 1) The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the •
arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the •
arrow until the appliance is level.
Assemble the handles after switching the side of 3.
the Fridge handle and the Freezer handle.
Tighten 2 screws underneath the Fridge door and 4.
then assemble 2 screws and 2 Cap sheets on
the Freezer door.
REVERSING THE DOOR
HANDLE (TYPE B)
Remove 2 screws underneath the Fridge door 1.
and then pull the Handle cover.
Disassemble the Handle cover carefully.
Hooks inside of the Handle cover can break
easily.
Remove 2 screws on the Handle grommets. 2.
Remove the Handle grommets and disassemble
the Easy handle.
Screw
Cover handle
Screw
handleGrommet
Spring
Slider
Screw
WARNING
DA99-02116A(0.7)-EN.indd 12DA99-02116A(0.7)-EN.indd 12 2012.10.8 9:24:24 AM2012.10.8 9:24:24 AM
Downloaded from Fridge-Manual.com Manuals