User manual
safety information _03
SEVERE WARNING SIGNS
FOR INSTALLATION
Do not install the refrigerator in a damp •
place or place where it may come in
contact with water.
Deteriorated insulation of electrical parts may -
cause an electric shock or fi re.
Do not place this refrigerator in direct sunlight or •
expose to the heat from stoves, room heaters or
other appliance.
Do not plug several appliances into the same •
multiple power board.
The refrigerator should always be plugged into
its own individual electrical which has a voltage
rating that matched the rating plate.
This provides the best performance and also -
prevents overloading house wiring circuits, which
could cause a fi re hazard from overheated wires.
If the wall socket is loose, do not insert the power •
plug.
There is a risk of electric shock of fi re. -
Do not use a cord that shows cracks or abrasion •
damage along its length or at either end.
Do not bend the power cord excessively or place •
heavy articles on it.
Do not use aerosols near the refrigerator.•
Aerosols used near the refrigerator may cause an -
explosion or fi re.
This refrigerator must be properly installed •
and located in accordance with the manual
before it is used.
Connect the power plug in proper position with •
the cord hanging down.
If you connect the power plug upside down, wire -
can get cut off and cause fi re or electric shock.
Make sure that the power plug is not squashed •
or damaged by the back of the refrigerator.
When moving the refrigerator, be careful not to •
roll over or damage the power cord.
This constitutes a fi re hazard. -
The appliance must be positioned so that the •
plug is accessible after installation.
The refrigerator must be grounded.•
You must ground the refrigerator to -
prevent any power leakages or electric
shocks caused by current leakage from
the refrigerator.
Never use gas pipes, telephone lines or other •
potential lightening rods as ground.
Improper use of the ground plug can result in -
electric shock.
If the power cord is damaged, have it •
replaced immediately by the manufacturer
or its service agent.
The fuse on the refrigerator must be changed by •
a qualifi ed technician or service company.
Failing to do so may result in electric shock or -
personal injury.
CAUTION SIGNS FOR
INSTALLATION
Keep ventilation opening in the appliance •
enclosure or mounting structure clear of
obstruction.
Allow the appliance to stand for 2 hours after •
installation.
SEVERE WARNING SIGNS
FOR USING
Do not insert the power plug with wet •
hands.
Do not store articles on the top of the appliance.•
When you open or close the door, the articles -
may fall and cause personal injury and/or material
damage.
WARNING
CAUTION
WARNING
DA99-02116A(0.7)-EN.indd 03DA99-02116A(0.7)-EN.indd 03 2012.10.8 9:24:21 AM2012.10.8 9:24:21 AM
Downloaded from Fridge-Manual.com Manuals