Use and Care Manual
English - 15
SETTING UP
1. Unscrew the nut (1) from the lower hinge until
it reaches the upper end of the bolt (2).
(2) Bolt
(
(2
(1) Nut
(1) Nut
(3) Wrench
(3) Wrench
When you release the nut (1), make sure
that you use the hex wrench provided
(3) to loosen the bolt (2) in a counter-
clockwise (
) direction.
You should then be able to unscrew the
nut (1) with your fi ngers.
2. Adjust the height difference between the doors
by turning the bolt (2) clockwise (
) or
counter clockwise ( ).
(2) Bolt
(2) Bolt
(3) Wrench
(3) Wrench
When you turn clockwise ( ), the
door will move up.
3. After adjusting the doors, turn the nut (1)
clockwise (
) until it reaches the lower
end of the bolt, then tighten the bolt again with
the wrench (3) to fi x the nut in place (1).
(2) Bolt
(
(2
(1) Nut
(1) Nut
(3) Wrench
(3) Wrench
If you do not secure the nut fi rmly, the bolt
may release.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator.
To help promote better health, the Samsung water
fi lter removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125psi (138 ~ 862kPa) is
required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly fi lled.
To do this, press the water dispenser lever until
water runs from the water dispenser.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water supply kit
that contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
The refrigerator should NOT be plugged in
at this point.
2. Locate the nearest cold water drinking water
line.
3. Install the pipe clamp and shut off valve.
4. Connect the water line installation kit to the
shut off valve.
Shut off valve
Shut off valve
Pipe clamp
Pipe clamp
Cold water line
Cold water line
Water line installation kit
Water line installation kit
SSEDA Drop In- EN.indd 15SSEDA Drop In- EN.indd 15 2015. 2. 6. 9:392015. 2. 6. 9:39