Quick Guide

If you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864).
Before installation or calling service
1. Leveling & Door Alignment
• For details, refer to “Adjust the leveling legs/door height” in the User Manual.
Leveling
• Insert a at-blade screwdriver into a slot on the control lever, turn it clockwise or counter-clockwise to
level the refrigerator.
CAUTION
You should level the refrigerator when it is empty. To level the refrigerator,
adjust the Leveling Leg Control by turning it clockwise or counterclockwise
with a at head screwdriver until the Leveling Legs contact the oor.
Control Lever
Flat-blade screw driver(-)
Door Alignment
• Open the door to adjust, and locate the two nuts (A) and (B) on the front bottom of the door.
B
A
• With a 19 mm spanner (not provided), turn the clamp nut (A) clockwise to loosen. Then, open the door,
and do the following inside the door.
- To raise the door, turn the height nut (B) counter clockwise.
- To lower the door, turn the height nut (B) clockwise.
• When complete, tighten the clamp nut (A) by turning it counter clockwise.
2. Automatic Ice Maker does not work
- Allow your refrigerator to operate and cool down for 24 hours (1 full day) before dispensing large
quantities of ice.
• To ll the ice bucket to maximum capacity, dispense a few cubes 8 and 16 hours after installation.
• If Ice Maker Off is lit, the ice maker will not make ice.
• To activate the ice maker, press the Ice Make button on the control panel so Ice Maker Off is no longer lit.
(applicable models only)
3. Water line is not connected
• Leaving the water line disconnected may cause the water valve to become noisy.
The valve will generate a buzzing sound over time. If the water line is not connected to the refrigerator or
turned off, make sure that the ice making function is set to “Ice Maker Off”.
Also, do not attempt to use the water dispenser.
4. Small ice cubes, ice cubes with bubbles, or slow water dispensing
• If the water lter is clogged, it may produce small ice cubes or bubbles inside the cubes.
• Please replace the lter cartridge.
• After replacing the lter, please dispense at least 3 gallons (2-3 minutes) of water to remove any trapped
air from the water line.
5. Water is not cool enough
• The rst glass of water may not be cold enough because the stored water in the water tank has not cooled
completely. Dispense several glasses of water until the water is cool enough.
6. Water dispenser dripping
• If the water line is not inserted into the coupler properly,
air could penetrate into the water line causing water to
drip from the water dispenser.
B
A
• The Water Line must be fully inserted to the center of
the transparent coupler (Type A) or the Guide Lines (Type
B) to prevent water leakage from the dispenser.
Center of Transparent coupler
The Guide Lines
Dispenser
Type A Type B
7. Fridge or freezer Compartments are warm
• Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach the temperature you
set.
• Also, when you put room temperature or warmer food into your refrigerator, it may need
an additional 24 hours to reach the set temperature.
8. Moisture forms on outside/inside of refrigerator
• Wipe off the condensation with a dry towel. (This may occur during hot and humid weather.)
• If the condensation appears on the doors, turn off the Energy Saving* function.
( * applicable models only)
• If you open the doors frequently or for too long, it may cause moisture to form inside the fridge.
9. Noise Clicks, Pops, Cracks, Snaps
• You may hear these noises occasionally from inside the refrigerator. This is normal.
These sounds occur when various items contract or expand while temperatures inside the fridge are
changing, especially during defrosting. You may also hear these noises when electronic devices, including
the ice maker, are operating.
10. Display (applicable models only)
• Filter indicator: The lter Indicator turns red after you use about 300 gallons of water
(about 6 months of usage). Replace the water lter, and then reset the indicator
(it will be Blue or off) by holding the lter reset button for 3 seconds.
• Ice off: Press the “Ice Maker” button to turn the ice making function off.
• Cooling Off (Show Room) mode: If the Display shows the “0F 0F” (or OFF) code, it means
that the Cooling Off function is activated and the refrigerator is not cooling.
To cancel the Cooling Off mode, press the multiple buttons on the display specied in the user’s manual.
11. Food stored in refrigerator is frozen
• If food with too much moisture is stored near the cooling vents, it may get frozen.
Be sure to keep moist food away from the cooling vents.
12. Moving the Refrigerator
• When moving the refrigerator, pull or push it straight forward
or backward.
Do not wiggle it from side to side.
DA68-02659C-00
DA68-02659C-00.indd 1 2019-10-24  8:33:27
DRAFT