Use and Care Guide

English 35
Maintenance
Door reversal (applicable models only)
WARNING
• As door reversal process requires tilting/laying the refrigerator on its side, empty the
fridge and icemaker and secure the doors before attempting the process.
• Tilting/laying the refrigerator requires minimum of 2 people.
• Disconnect power source and water line before reversing the doors.
• To facilitate the door reversal process, you will need to lay the refrigerator down. If
the unit is allowed to lay on its back or side for more than an hour, let it stand for 15
minutes after it is returned to the upright position before plugging it in.
Tools required (not provided)
Phillips screwdriver Flat-head screwdriver
7
/16" (11 mm) spanner
(for hinge shaft)
5
/16" (8 mm) socket wrench
(for bolts)
3
/8" (10 mm) socket wrench
(for bolts)
3
/16" (5 mm) Allen wrench
(for middle hinge)
Accessories (provided)
Hinge cover *
* Hinge cover is located on the top table. (refer to page 47.)
CAUTION
Throughout the entire reversing procedure, keep all the small parts (screws, caps, etc.) of
the refrigerator away from children or infants for safety reasons.
Maintenance
Untitled-5 35 2017-07-20  6:30:59