Installation Guide 2021.09.14
Table Of Contents
- TMF_RT6500M_DA68-03648A-04_EN
- TMF_RT6500M_DA68-03648A-04_MES
- TMF_RT6500M_DA68-03648A-04_CFR
English4
Installation
Before connecting the water line
To use the ice maker, you must connect the water line to it. For the ice maker to operate
properly, a water pressure of 20 - 125 psi (0.138 - 0.862 mPa) is required.
WARNING
Make sure to connect the water line only to a potable water source.
CAUTION
• Do not reuse an old hose set. Use the new hose sets supplied with your refrigerator
only.
• The water line installation is not covered by the Warranty of this product. Read carefully
through these instructions to protect your property and prevent possible damage.
• Banging pipes (water banging in the pipes) can cause damage to the refrigerator, and
lead to water leakage or ooding. If you encounter this problem, contact a plumber for
professional assistance.
• To prevent burns and product damage, do not connect the water line to a hot water
source.
• Do not install the water line in areas where temperatures fall below the freezing point.
• When using any electrical device (such as a motorized drill) during installation, be sure
the device is insulated and properly grounded to prevent electric shock.
• All installations must be in accordance with local plumbing code requirements.
• The water lter must be replaced as instructed by the manufacturer or the retailer.
• To purchase additional water lters, contact the manufacturer or the retailer of the lter.
NOTE
• You can purchase the water line installation kit from your retailer. We recommend using
a kit that contains copper tubing and a 6 mm (
1
/4”) compression nut.
• In an area with low water pressure (below 20 psi (0.138 mPa)), you can install a booster
pump to compensate for the low pressure.
Installation
Untitled-1 4 2021-09-06 10:46:59