Installation Guide 2021.09.14

Installation
English6
Installation
To install the ice maker kit
WARNING
Refrigerator must be disconnected from the source of electrical supply before attempting
the installation.
A
A
1. Remove the screws tightening the water
inlet cover (A) located on the top of the
refrigerator. Then, slide out the water
inlet cover (A) to remove.
- After removing the water inlet cover
(A), remove the aluminum seal.
A
2. Remove the pipe plug foam (A) from the
pipe.
A
B
3. Slide the exible tube (A) towards the
water inlet tube (B) (with a white water
line) and secure it to the water inlet tube
(B).
NOTE
Do not remove the cap plugged in at the
end of the white water line.
Untitled-1 6 2021-09-06  10:47:00