User Manual

English 19
Installation
STEP 4 Connect the water line (optional)
Connect the water line to the ice maker. For the ice maker to operate properly, a water
pressure of 20-125 psi (138-862 kPa) is required. After you have connected the water line,
make sure the water storage tank inside the refrigerator is properly lled.
CAUTION
• Use the new hose-sets supplied with the appliance only. Do not re-use an old hose set.
• The water line installation is not covered by the Warranty of this product. Read carefully
through these instructions to protect your property and prevent possible damage.
• Banging pipes (water banging in the pipes) can cause damage to the refrigerator, and
lead to water leakage or ooding. If you encounter this problem, contact a plumber for
professional assistance.
• To prevent burns and product damage, do not connect the water line to a hot water
source.
• Do not install the water line in areas where temperatures fall below the freezing point.
• When using any electrical device (such as a motorized drill) during installation, be sure
the device is insulated and properly grounded to prevent electric shock.
• All installations must be in accordance with local plumbing code requirements.
• The water lter must be replaced as instructed by the manufacturer or the retailer.
• To purchase additional water lters, contact the manufacturer or the retailer of the lter.
NOTE
• You can purchase the water line installation kit from your retailer. We recommend using
a kit that contains copper tubing and a 6 mm (
1
/4”) compression nut.
• In an area with low water pressure (below 20 psi (138 kPa)), you can install a booster
pump to compensate for the low pressure.
Untitled-6 19 2020-11-11 PM 2:43:41