Laptop User Manual

UART S3C2440A RISC MICROPROCESSOR
11-14
UART FIFO CONTROL REGISTER
There are three UART FIFO control registers including UFCON0, UFCON1 and UFCON2 in the UART block.
Register Address R/W Description Reset Value
UFCON0 0x50000008 R/W UART channel 0 FIFO control register 0x0
UFCON1 0x50004008 R/W UART channel 1 FIFO control register 0x0
UFCON2 0x50008008 R/W UART channel 2 FIFO control register 0x0
UFCONn Bit Description Initial State
Tx FIFO Trigger Level [7:6] Determine the trigger level of transmit FIFO.
00 = Empty 01 = 16-byte
10 = 32-byte 11 = 48-byte
00
Rx FIFO Trigger Level [5:4] Determine the trigger level of receive FIFO.
00 = 1-byte 01 = 8-byte
10 = 16-byte 11 = 32-byte
00
Reserved [3] 0
Tx FIFO Reset [2] Auto-cleared after resetting FIFO
0 = Normal 1= Tx FIFO reset
0
Rx FIFO Reset [1] Auto-cleared after resetting FIFO
0 = Normal 1= Rx FIFO reset
0
FIFO Enable [0] 0 = Disable 1 = Enable 0
Note
When the UART does not reach the FIFO trigger level and does not receive data during 3 word time in DMA receive mode
with FIFO, the Rx interrupt will be generated (receive time out), and the users should check the FIFO status and read out the
rest.