DA-E670 Wireless Audio with Dock user manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www.samsung.
features AllShare Play Play music saved on your devices (such as your PC, Smart phone, or NAS) through the Wireless Audio with Dock via a network connection. AirPlay Play music saved on your Apple devices on the Wireless Audio with Dock. Dual Docking Audio Speaker System Using the system's dual docking station, dock, charge, and then play either Samsung Galaxy devices or Apple devices through the system's built-in speakers.
EnG safety information Safety Warnings CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lighting flash and arrowhead within the triangle indicates that there is dangerous voltage Inside the product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The explanation point within the triangle indicates that there are important instructions accompanying the product.
PrecaUtions 2.7 inch 3.9 inch 3.9 inch 3.9 inch Ensure that the AC power supply in your house complies with the power requirements listed on the identification sticker located on the back of your product. Install your product horizontally, on a suitable base (furniture), with enough space around it for ventilation (3~4 inches). Make sure the ventilation slots are not covered. Do not place the unit on amplifiers or other equipment which may become hot. This unit is designed for continuous use.
EnG contents features 2 2 Features License safety information 3 4 Safety warnings Precautions getting started 6 6 Before reading the user’s manual What’s included descriptions 7 Top/Front/Rear Panel remote control 9 Tour of the remote control power on and volume control 10 10 Turning the Power on/off Adjusting the volume connections 11 Installing the Toroidal ferrite on the Power cable Using the Spacer Cover Connecting a device to the Dual Dock Connecting an audio device using AUX IN Co
getting started Before Reading the User’s Manual Note the following terms before reading the user manual. Icons used in this manual Icon Term Caution Note Definition Indicates a situation where a function does not operate or settings may be canceled. Indicates tips or instructions on the page that help a function operate. Safety Instructions and Troubleshooting 1) Familiarize yourself with the Safety Instructions before using this product. (See page 3) 2) If a problem occurs, check Troubleshooting.
EnG descriptions DOCK TOP/Front/Rear Panel LAN DC 14V 4A WPS/ RESET AUX IN USB 5V 500mA 1 DOCK ● Descriptions 2 DC 14V 4A 3 LAN WPS/ RESET AUX IN USB 5V 500mA 4 LAN DC 14V 4A WPS/ RESET AUX IN USB 5V 500mA PUSH LAN DC 14V 4A WPS/ RESET AUX IN ONLY FOR SERVICE 5 USB 5V 500mA LAN DC 14V 4A WPS/ RESET AUX IN USB 5V 500mA PUSH LAN DC 14V 4A WPS/ RESET AUX IN ONLY FOR SERVICE USB 5V 500mA PUSH 6 LAN DC 14V 4A 7 WPS/ RESET AUX IN ONLY FOR S
PLAY/PAUSE BUTTON Play or pause a music file. FUNCTION BUTTON Switches the mode as follows : ; ; ; ; ; ; AUX (LED Off) VOLUME +/BUTTON Controls the volume level. FUNCTION DISPLAY When you change the mode with the Function button, the icon of the selected mode is displayed in white on the Function Display. The LED blinks when you turn the power on and stops blinking when the unit is on and ready to play.
EnG remote control Tour of the Remote Control FUNCTION ● remote control POWER BUTTON Turns the unit on and off. FUNCTION BUTTON Selects the Function mode. PLAY/PAUSE BUTTON Play or pause a music file. CONTROL BUTTON Search for the next or previous music file. MUTE VOL BASS VOLUME Adjusts the volume level of the unit. MUTE BUTTON Mutes the sound from this unit. Press again to restore the sound to the previous volume level. BASS BUTTON Optimize the sound based on your tastes.
power on and volume control DOCK tUrning the PoWer on/off DOCK DOCK DOCK FUNCTION or FUNCTION MUTE VOL BASS MUTE VOL DOCK BASS DOCK 1. To turn on this unit, press any button on the unit's top panel when the unit is in Standby mode. or, Press POweR on the remote control. 2. To turn off this unit, press the +# button on the unit's top panel for more than 3 seconds. or, Press POweR on the remote control again. DOCK adJUsting the VoLUMe DOCKvolume.
ENG connections instaLLing the toroidaL ferrite on the PoWer caBLe ● CONNECTIONS Lift up to release the lock and open the core. Close the lock back. Wind Power cable around the core three times.
Using the sPacer coVer Attach the space cover if you want to dock a Samsung Galaxy or Apple device having no protective case onto the Dual Dock. - Use it for stable installation of your device considering the shape of the device. The Dual Dock also comes with a protective cover for the 30-pin Apple device connector. Use the protective cover for the 30-pin connector when you attach the 5-pin Samsung Galaxy device. See the illustrations below for additional instructions.
ENG connecting a deVice to the dUaL docK How to connect a device to the Dual Dock.
CONNECTING AN AUDIO DEVICE USING AUX IN This section explains how to connect the unit to an audio device. PUSH This unit is equipped with one audio analog jack for connecting an audio device.
You can connect your Wireless Audio with Dock to your network router using one of the methods illustrated on the next few pages.
To connect the Wireless Audio with Dock to a Wireless Network This section describes 4 methods of connecting the Wireless Audio with Dock to a wireless network. ▪▪ Some of network related operations may be different than explained depending on performance and supported functions of used AP. ▪▪ To configure the network connection to your router or modem, see the router or modem's user manual.
EnG To connect the Wireless Audio with Dock using WPS (PBC) 1. Press the button on the top panel of the Wireless Audio with Dock repeatedly until the or icon appears in the display. DOCK • Each time you press the button, the selection changes as follows : ; ; ; ; ; ; AUX (LED Off) The indicator changes from white to red and blinks. LAN DC 14V 4A WPS/ RESET AUX IN ONLY FOR SERVICE USB 5V 500mA ● connections 2.
To connect the Wireless Audio with Dock through a JBC (JukeBox Connect) Connection 1. Press the button on the top panel of the Wireless Audio with Dock repeatedly until the icon appears in the display. or • Each time you press the button, the selection changes as follows : ; ; ; ; ; ; AUX (LED Off) The indicator changes from white to red and blinks. 2. Press and hold the WPS/RESET button on the back panel with a pen tip or similar item for more than 5 seconds. The indicator blinks in white once.
1. Press the button on the top panel of the Wireless Audio with Dock repeatedly until the icon appears in the display. EnG To connect the Wireless Audio with Dock using a WPS PIN or • Each time you press the button, the selection changes as follows : ; ; ; ; ; ; AUX (LED Off) The indicator changes from white to red and blinks. • The icon blinks in red, and then stops blinking and glows in red when the unit accesses the Network Setting mode. 3.
BLUETOOTH You can connect the Wireless Audio with Dock to Bluetooth devices and enjoy music with high quality stereo sound, all without wires! What is Bluetooth? Bluetooth technology lets Bluetooth-compliant devices interconnect easily with each other using a short wireless connection. • A Bluetooth device may cause noise or malfunction, depending on usage, when: -- A part of your body is in contact with the receiving/transmitting system of the Bluetooth device or the Wireless Audio with Dock.
EnG CONNECTING TO BLUETOOTH DEVICES This section explains how to connect the Wireless Audio with Dock to Bluetooth compatible TVs and other Bluetooth devices. To connect the Wireless Audio with Dock to a Bluetooth compatible 2012 Samsung TV (SoundShare) DOCK ● connections Connect To produce TV sound on your Wireless Audio with Dock via Bluetooth connection, you need to pair your system to the Bluetooth compliant TV first.
To connect the Wireless Audio with Dock to a Bluetooth device Before you begin, confirm that your Bluetooth device supports the Bluetooth compliant stereo headset function. DOCK DOCK DOCK Connect External device 1. Press the display. button on the top panel of the Wireless Audio with Dock repeatedly until the icon appears in the • Each time you press the button, the selection changes as follows : ; ; ; ; ; ; AUX (LED Off) • The selected mode is displayed in white in the Function Display. 2.
EnG playing DOCK USING THE TV MODE (SoundShare) ● playing Press the button to select the mode, and then connect the TV to the Wireless Audio with Dock. (See page 21) • The unit will play the TV's audio when it is connected to the TV. • If you change the Wireless Audio with Dock's Bluetooth input source or turn it off, you will hear audio from the TV again. ▪▪ You can control the volume only with the Wireless Audio with Dock.
▪▪ Once you started the application, running is not disturbed by charging your mobile device with an ordinary charger. ▪▪ When you connect other device to the Wireless Audio with Dock after connecting Samsung Galaxy device in docking mode, you may have to turn off the Bluetooth mode of the Samsung Galaxy device. ▪▪ If you have trouble connecting the Samsung Galaxy device to the Dual Dock, turn off the devices's Bluetooth mode. 1.
DOCK EnG USING THE BLUETOOTH MODE Press the button to select the mode, and then connect the Bluetooth device to the Wireless Audio with Dock. (See page 22) To connect your Bluetooth device when the Wireless Audio with Dock is in Bluetooth mode, search for the Wireless Audio with Dock on the device's Bluetooth list. Select the Wireless Audio with Dock, and then connect. Once the Wireless Audio with Dock has connected, select and play the desired music.
DOCK USING THE USB MODE 1. Connect the USB device to the USB port on the back of the unit. 2. Press the button on the top panel of the Wireless Audio with Dock repeatedly until the icon appears in the display. • Each time you press the button, the selection changes as follows : ; ; ; ; ; ; AUX (LED Off) • The selected mode is displayed in white in the Function Display. Before you connect a USB device Read the list below to check compatibility.
EnG USING airplay and allshare play mode DOCK To use the or function, the Wireless Audio with Dock and the device which you are trying to connect must be connected to the same AP. 1. Play the desired music in the menu on main screen of the Apple device. icon on the screen of ● playing 2. Select "Samsung W_Audio E670 XXXXXXX" by pressing the the Apple device. • The music will play through the Wireless Audio with Dock's speakers.
functions Basic fUnctions Using the input mode DOCK DOCK DOCK You can select the following inputs: ; ; ; ; ; ; aUX (Led off). Press an appropriate button on the remote control to select a desired mode, or press to select from: ; ; ; ; ; ; aUX (Led off).
POWER FUNCTION VOL MUTE VOL BASS FUNCTION Play/Pause During playback, press the +# button. MUTE VOL EnG advanced functions BASS • Press the +# button to stop playing the file temporarily. Press the +# button again to play the selected file. ● functions ▪▪ This function may not operate in certain mode. POWER FUNCTION VOL MUTE VOL BASS FUNCTION During playback, press the [,] button.
SOFTWARE UPGRADE (only USB mode) 1. Visit www.samsung.com. DOCK 2. Click SUPPORT on the top right of the page. 3. Enter the product's model number into the search field, and then click Find Product. PUSH LAN DC 14V 4A WPS/ RESET 4. Click Get downloads in the Center of the page below the Downloads header. 5. Click Firmware in the Center of the page. 6. Click ZIP file icon of the upgrade file. AUX IN ONLY FOR SERVICE USB 5V 500mA LAN DC 14V 4A WPS/ RESET 7.
EnG troubleshooting Before requesting service, please check the following. Symptom Check Remedy • I s the power cord plugged into the outlet? • Connect the power plug to the outlet. A function does not work when the button is pressed. • Has the Wireless Audio with • Disconnect the power plug Dock or the remote been and connect it again. exposed to static electricity? Sound is not produced.
appendix Specifications Model name DA-E670 GENERAL AMPLIFIER Power supply DC 14V 4A Power consumption 29.8W Weight 9.26 Ibs Dimensions (W x D x H) 15.7 x 7.9 x 5.
Warranty LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by Samsung Electronics America, Inc.
Open Source Announcement To send inquiries and requests for questions regarding open sources, contact Samsung via Email (oss.request@samsung.com). • This product uses some software programs which are distributed under the Independent JPEG Group.
QUESTIONS OR COMMENTS? COUNTRY CALL OR VISIT US ONLINE AT WRITE IN THE US 1-800-SAMSUNG (726-7864) www.samsung.com/us Samsung Electronics America, Inc. 85 Challenger Road Ridgefield Park, NJ 07660-2112 Code No.