User Manual

English - 27
OPERATING
CAUTION
• If a power failure occurs, ice cubes may melt
then freeze together when the power comes
back on and prevent the dispenser from
working properly.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
• If you use all the ice at once, you must
repeat Steps 2, 3, and 4 on the previous
page under Making Ice.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
USING THE ICE OFF FUNCTION
When you select the Ice O mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it dicult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly straight
back.
• If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
• The inside of the ice bucket is very cold when
the refrigerator is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator.
The water supply to this refrigerator must only
be installed/connected by a suitably qualified
person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125psi is required.
GOING ON VACATION...
If you are going on a long vacation or business trip
and won’t use the water or ice dispensers for a
long time:
- Close the water valve.
Otherwise, water leakage may occur.
- Remove all food and the ice in the ice bucket.
- Unplug the refrigerator.
- Wipe excess moisture from inside and leave the
doors open.
Otherwise, odor and mold may develop.
DA68-03194D-01.indb 27 15. 1. 8. �� 11:06