Installation Guide

installing the dishwasher _21

02 INSTALLING THE DISHWASHER

STEP 12 COMPLETING THE INSTALLATION

1. Open the door and remove all foam, paper packaging, and unnecessary parts.

2. Turn on the circuit breaker you turned o before you began the installation.

3. Open the water supply valve to supply water to the dishwasher.

4. Turn on the dishwasher, and then select and run a cycle.

Check if the power turns on correctly and if there is any water leakage while the dishwasher

is operating. If no errors occur while it is operating, turn o the dishwasher, and then go to

Step 5 below.

If an error has occurred, turn o the dishwasher, close the water supply valve, and then

refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).

Make sure to check for water leakage on both ends of the water supply line and drain hose

connector.

CAUTION

Installation_DD81-02034B-00_EN.indd Sec3:21Installation_DD81-02034B-02_EN.indd Sec3:21 /10/2016 10:56:06 AM255/08/2017 10:56:06 AM

5. Conﬁ rm that the kick plate gasket is on the bottom of the kick plate. Insert the rubber skirt

behind the kick plate, and tighten the kick plate using the screws included in the Install Kit.

See the ﬁ gures below for reference.