SC07F70 Series SC08F70 Series SC20F70 Series Vacuum Cleaner user manual ✻ Please read the User Manual thoroughly before operating the vacuum. ✻ For indoor use only. English Thank you for purchasing a Samsung product. DJ68-00701A (EN)-07.indd 1 2014. 12. 19.
Contents YOUR VACUUM CLEANER 7 BEFORE USING THE VACUUM CLEANER 8 OPERATING CLEANER 12 MAINTENANCE 15 8 9 9 10 Assembly Using the UV brush (Option) Installing the Dust Sensor (Option) Using accessory 12 12 12 13 14 Power cord Check filter ON/OFF Power control Dust Sensor (Option) 15 Cleaning the dust bin and grille 18 Cleaning the outlet filter 19 Maintain floor tools TROUBLESHOOTING 22 PRODUCT FICHE 23 DJ68-00701A (EN)-07.indd 2 2014. 12. 19.
Safety information SAFETY INFORMATION WARNING WARNING • Before operating the appliance, please read this manual thoroughly and retain it for your reference. • Because the following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual. CAUTION/WARNING SYMBOLS USED WARNING CAUTION Indicates that a risk of death or serious injury exists. Indicates that a risk of personal injury or material damage exists.
IMPORTANT SAFEGUARDS GENERAL • Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner. • WARNING : D o not use the vacuum cleaner when rug or floor is wet. Do not use to suck up water. • Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy.
• • • • • • • Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision. Children should be supervised to ensure that they do not play with the appliance. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. The use of an extension cord is not recommended. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent.
• When the UV lamp is out of order, never disassemble or modify the product yourself. Please contact the manufacturer or service center for a replacement. • Since an internal discharge occurs within the UV Brush, never use the product near an inflammable spray or substance. • Take care not to touch the UV lamp window after using the UV Brush for an extended period of time as the surface of the window may be hot.
Your vacuum cleaner Handle Combination accessory Pipe Your vacuum cleaner Hose 2-Step brush Cyclone OPTION (Depending on model) * SC20F70U / SC07F80U Series Power turbo plus * ECO carpet* Parquet master * Mini turbo * Cover battery * Dust sensor * 2-Step brush * Furniture brush * ECO Hard floor* Pipe * Handle * UV brush * 2-in-1 accessory * English - 7 DJ68-00701A (EN)-07.indd 7 2014. 12. 19.
Before using the vacuum cleaner ASSEMBLY Connecting the Hose Connecting the handle and pipe Connecting the brush English - 8 DJ68-00701A (EN)-07.indd 8 2014. 12. 19.
USING THE UV BRUSH (OPTION) Connecting the brush into the hose handle Before using the vacuum cleaner There will be a “clicking” sound when the UV brush has been installed securely on the hose handle. For safety reasons, UV brushing only runs for 30 minutes and then stops operating. To resume the operation, press the [BRUSH ON/OFF] button again. CAUTION The UV brush, which is assembled into the hose handle (not directly connected to the pipe), is dedicated for bedclothes.
USING ACCESSORY Combination accessory (Option) 2 1 Dusting brush Crevice tool Accessories (Option) Install the accessory to the handle. Dusting brush Crevice tool Dusting brush - For cleaning moldings, carved articles. etc. Crevice tool - For cleaning in folds, crevices and corners. English - 10 DJ68-00701A (EN)-07.indd 10 2014. 12. 19.
Pipe Adjust the length of the pipe by sliding the length control button located in the center of the telescopic pipe. Before using the vacuum cleaner For storage, park the floor nozzle CAUTION Do not pick up a machine while the floor nozzle parked. English - 11 DJ68-00701A (EN)-07.indd 11 2014. 12. 19.
Operating cleaner POWER CORD CAUTION When removing the plug from the electrical outlet, grasp the plug, not the cord. CHECK FILTER ON/OFF The filter light is illuminated when the dust pack requires checking or emptying. English - 12 DJ68-00701A (EN)-07.indd 12 2014. 12. 19.
POWER CONTROL Hose (controlled by radio frequency signals) ON/OFF SC07F70H / SC08F70H / SC20F70H Series Transmitter Operating cleaner Select a lower power / higher power Select a quiet mode -/+ SC07F70U / SC08F70U / SC20F70U Series Transmitter Select a lower power / higher power UV brush ON/OFF • UV sterilization cannot be activated by itself. • Press the [SUCTION (-/+)] and [BRUSH ON/OFF] for operation. • Don’t cover the handle transmitter when you use a handle control.
DUST SENSOR (OPTION) Dust Sensor Operations • Indicates the amount of dust being picked up and passing by the sensor which assist the user to clean more efficiently. • The dust sensor is activated au tomatically when the cleaner runs and is turned off when the cleaner is stopped. Green : Amount of dust passing sensor is small. Red : Amount of dust passing sensor is large. If the red light does not light up when cleaning a dusty location -- Clean the sensors (2EA) with a dry cloth.
Maintenance CLEANING THE DUST BIN AND GRILLE Empty the dust bin, if dust reaches 'MAX' or Check filter ( ) light is illuminating. 1 Maintenance Take the dust bin out by lifting the handle. Push the button aside. Turn the grille and take out it. 2 3 4 English - 15 DJ68-00701A (EN)-07.indd 15 2014. 12. 19.
Push the button. Separate the dust bin from body. 5 Clean the dust bin and body with water. 6 Leave the dust bin and body in the shade until completely dry. CAUTION 7 Install the grille and turn to clockwise. 1 2 English - 16 DJ68-00701A (EN)-07.indd 16 2014. 12. 19.
CLEANING THE DUST FILTER 1 2 Maintenance Pull the dust bin cover to open. Remove the filter from the dust bin. 3 4 Shake the filter to remove dust, then wash the filter. Let the filter dry for more than 12 hours. 5 Put the filter into the dust bin. Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry. Do not use wet filter. Replace the dust filter if it becomes damaged or deformed.
CLEANING THE OUTLET FILTER 1 2 Take the dust bin out by lifting the handle. 3 Pull out the Filter. 4 Shake the Filter to clean. Install the filter and holder in main body. • The filter can be replaced and separated from holder by pulling. • Clean the outlet filter when suction is noticeably reduced continuously or the vacuum cleaner abnormal overheads. Note: Filters are not washable. Replace filter if cleaning does not resolve the problem. • Recommend that Filter should be changed once in 6 month.
MAINTAIN FLOOR TOOLS 2-Step Brush Maintenance • Adjust the inlet lever according to the floor surface. Floor Carpet • Remove waste matter completely if the inlet is blocked. Power Turbo Plus Brush (Optional Accessory) 1 2 3 4 1 2 Frequent vacuuming of hair or pet fur may reduce cleaning effectiveness over time due to matters tangled around the drum. In this case, clean the drum with care. English - 19 DJ68-00701A (EN)-07.indd 19 2014. 12. 19.
To remove dust from the dust bin of the UV brush (Option) When the dust bin is filled, turn the [Dust Removal] switch to empty the dust bin. Dust bin • While the cleaner is operating (suction), the vacuum will suck the material from the dust bin to the main unit. • While the [Dust Removal] switch is in the position, the suction power of the cleaner is reduced.
Mini turbo brush (Optional Accessory) - To check brushroll Maintenance Check brushroll, when a clog is present or debris is visible. - To check belt Inspect belt to ensure that it is in good condition. If belt is broken or cracked, replace belt according to instructions. English - 21 DJ68-00701A (EN)-07.indd 21 2014. 12. 19.
Troubleshooting PROBLEM SOLUTION Motor does not start. • Check cable, plug and socket. • Leave to cool. Suction force is gradually decreasing. • Check for blockage and remove. In operation, the vacuum cleaner stops • Please unclog the intake. after repeating runs and stops three times. Cord does not rewind fully. • Pull the cord out 2-3 m and push down the cord rewind button. Vacuum cleaner dows not pick up dirt. • Check hose and replace if required. Low or decreasing suction.
Product fiche [English] According to Commission Regulation (EU) No 665/2013 and No 666/2013 A Supplier B Model Samsung Electronics., Co.
If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care center. COUNTRY CUSTOMER CARE CENTER WEB SITE U.K 0330 SAMSUNG (7267864) www.samsung.com SOUTH AFRICA 0860 7267864 (SAMSUNG) www.samsung.com DJ68-00701A-07 DJ68-00701A (EN)-07.indd 24 2014. 12. 19.