Operation Manual
English_27
● CAMERA OPERATION
DISP ID : Display camera title on top left corner of the screen.
FONT COLOR : You can change the OSD font color. (White, Yellow, Green,
Red, Blue)
LANGUAGE : You can select the menu language according to your requirements.
RETURN : Return to the SPECIAL menu.
This function sets up the camera communication status when controlling the
camera through an external control device.
❶
If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
‘COMM ADJ’.
❷
Select a desired mode using the
Function Setup switch.
PROTOCOL : Select the
communication
PROTOCOL.
(SAMSUNG-T, SAMSUNG-E, PELCO-D, PELCO-P, BOSCH,
HONEYWELL, VICON, PANASONIC, GE and AD)
CAM ID : Determines the camera's identification number (between 0 and 255).
BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps .
UART MODE : You can select NONE, EVEN or ODD for the parity bits.
RET PKT : Determines whether to send a command back to the controller device
when a communication control command is sent to the camera.
COAX : You can select whether to use COAX communication.
RETURN : Return to the SPECIAL menu.
❶
If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
‘IMAGE ADJ’.
❷
Select a desired mode using the
Function Setup switch.
GAMMA : The setting range is 0.2 ~
1.0. The closer to 1.0 the
setting is, the darker it gets.
-
-
-
-
-
-
-
-
-
-
-
-
COMM SETUP
▶
1.
PROTOCOL
SAMSUNG-T
2.
CAM ID
------
1
3.
BAUD RATE
9600
4.
UART MODE
8-N-1
5.
RET PKT
ENABLE
6.
COAX
ON
7.
RETURN
IMAGE SETUP
▶
1.
GAMMA
0.45
2.
PED LEVEL
----
----
50
3.
COLOR GAIN
----
----
50
4. H-REV OFF
5. V-REV OFF
6. D-ZOOM OFF
7. SHARPNESS MIDDLE
8. PFR
OFF
9.
RETURN