Operating instructions

37
Operating InstructionsOperating Instructions
36
– Setting H-REV (refer to the diagram below)
Move the cursor to “H-REV” and select “ON/ OFF”
using the right/left selection switch.
When “OFF” is selected, video signal is output normally.
When “ON” is selected, video signal is output in
right/left reverse.
– Setting V-REV (refer to the diagram below)
Move the cursor to “V-REV” and select “ON/ OFF”
using the right/left selection switch.
When “OFF” is selected, video signal is output normally.
When “ON” is selected, video signal is output in
up/down reverse.
9) MOTION DET MODE
Move the cursor to “MOTION DET” and select
“ON---/OFF” using the right/left selection switch.
When “OFF” is selected, motion detection is not made.
When “ON---” is selected, range and level for the
motion detection can be set.
When the MOTION is detected, ALARM OUT terminal
becomes Gnd and the ALARM is lifted automatically
about 30 seconds later. (GND/OPEN)
(VIDEO CONTROL)
0
POSI
OFF
OFF
RS485 ADDR
H-DTL
V-DTL
POSI/NEGA
H-REV
V-REV
RET
--------
--------
The setting of the MOTION DET MENU is as follows:
Move the MOTION DETECT range selection cursor
to “AREA SET---” and press the Setup Switch to see
the MOTION AREA. Select the AREA location using
the right/left direction switch and press the Setup
Switch. Then the range for MOTION detection is
turned off. Press it once more to turn it on.
(However, location can be set only when the PRESET
is OFF. When it is ON, the conditions are fixed to as
they are right before the shipment.)
When the location selection is completed, press the
Setup Switch for longer than 2 seconds to return to the
previous MOTION DET MENU.
(SET UP)
OFF
OFF
ALC---
OFF
ON
ATW
INT
FIX
ON---
QUIT?
CAMERA ID
SENSE UP
ALC/ELC
BLC
AGC
WHITE BAL
SYNC
VIDEO CON
MOTION DET
EXIT
00107A SCC-833P/855P - gb 11/22/00 3:36 PM Page 36