User Manual

installation & connection
14_ installation & connection
3.MD_OUT
4.RS_485+
1.GND
2.EXT_DN
5.RS_485-
Installation
1. Attach the installation template to the
selected area and punch 2 holes as shown in
the figure.
2. Use the 2 supplied screws to fix the camera
to the 2 punched holes.

Set the <FRONT TOP> mark imprinted on the
camera to face the direction of camera monitoring.
3. Connect the camera internal terminal with the
corresponding cable.
4.
Adjust the lens in a desired direction by
referring to the “Adjusting the monitoring
direction for the camera” section. (page 15)
5. Fasten the dome case (dome cover +
camera case) to the main body as shown in
the figure.
J

Pay attention to the direction for assembly.