User Manual

installation & connection
18_ installation & connection
Default rS-485 communication settings
J
`
When constructing a proprietary controller for direct camera control, apply Pelco-D or Samsung-
Techwin protocol.
`
Use only a DVR model that supports HD-SDI saving.
Item CAM ID BAUD RATE UART MODE RET PKT
Default 1 9600 8-N-1 DISABLE
External Day/Night Switching Input
Day/Night mode of the camera can be switched by signal from an external device.
M
`
To use this function, <DAY/NIGHT> setting of the camera should be set to the <EXTERN>.
(Page 28)
Motion Detection Signal Out
Upon a motion detection, the port outputs signal for an external device for display or operation.
When a motion is detected, the port outputs 3.3V signal.
M
`
To use this function, <ALARM OUT> setting of the camera should be set to <ON>. (Page 33)
HD-SDI Monitor
POWER