User's Manual

43
Editing a Contacts Entry
Editing Contacts Name and Numbers
1. Find the Contacts entry you wish to change. (For more
information, refer to “Finding a Contacts Entry” on
page 39.)
2. Use the Navigation key to highlight the entry and press
VIEW ( ). The View Contact screen appears in the display
showing the highlighted entry’s information.
3. Use the Navigation key to review the information for the
entry that you wish to change, then press EDIT ( ). The
Edit Contact screen appears in the display.
4. Use the Navigation key to highlight the particular
information you want to add or change.
• Press to backspace and delete numbers or letters.
• Press and hold to clear all numbers or letters in the
highlighted field.
• Press the Options soft key.
The following options pop-up in the display:
– Set Speed Dial / Remove Speed Dial — Assign/remove a speed dial
number. (For more information, refer to
“Speed Dial” on page 46..)
– Set as default — Set the number the phone will dial when Contacts
dialing or speed dialing.
– Wait — A hard pause (waits for input from you).
– 2-Sec Pause — A 2-second pause after which dialing resumes. (For
more information, refer to
“Add Pauses to Contacts Numbers”
on page 43.)
Select the desired option.
5. When you’re finished changing the Contacts entry:
• To save your changes, press .
• To discard your changes, press . You are prompted to confirm
exiting without saving your changes. Press the Yes soft key to
discard your changes.
Add Pauses to Contacts Numbers
Calls to automated systems such as banking services often
require a password or account number. Instead of manually
entering these numbers, you can store them in a Contacts entry
with the phone number and with special characters called
pauses, up to a maximum of 32 digits.
• Wait — Stops the calling sequence until the phone receives further
input.
• 2-Sec Pause — Stops the calling sequence for two seconds, then
sends the remaining digits.
Note: You can enter multiple 2-Sec Pauses to extend the length of a pause.
For example, two consecutive 2-Sec Pauses cause a total pause time
of four seconds. Keep in mind that pauses count as digits towards the
32-digit maximum.