User manual

16_ Connection
Connection
½
RS-485 Communication establishment initial value.
Item
Camera ID
BAUD RATE UART MODE RET PKT
Initial value
1
9600 8-NONE-1 ENABLE
When making a control system to control the camera, please use to the protocol SAMSUNG-T,
SAMSUNG-E, PELCO-D , PELCO-P, BOSCH, HONEYWELL, VICON, PANASONIC, AD, GE.
When you connecting to RS-485 CONTROL TERMINAL, please peel off the outer skin inside the
RS-485 CONTROL TERMINAL.
USING COAXIAL COMMUNICATIONS
CAMERA
DVR CONTROLLER
SET MENU/ENTER OSD KEY
UP UP KEY JOYSTICK UP
DOWN DOWN KEY JOYSTICK DOWN
LEFT LEFT KEY JOYSTICK LEFT
RIGHT RIGHT KEY JOYSTICK RIGHT


• Coaxial Communications System
• OSD Control method
• If you set the sensitivity level of the sub menu item (of COAX) to “Low”, you have to
press the MENU/ENTER (OSD KEY) button twice in a row to access the OSD menu.
(To prevent an error by noise from the DVR)
(2) Connection to a DVR or System Controller.
Connect the RS-485 cable to the connection ports of the DVR or System Controller.
485 Contr
ol Board Connection Port RS-485 Control Port
(+) CONNECTION
TERMINAL (TRX+)
(-) CONNECTION TERMINAL (TRX-)
y
M
otion detection signals are output through
this terminal.
y
Used for earth-grounding.
(1) Connection to a PC.
Connect the camera to the PC via a RS-485 converter using RS-485 and a serial cable.
EX)
SERIAL PORT OF THE PC(COM1)

SERIAL CABLE

RS-485 CONVERTER

RS-485 CONTROL CABLE
MD
-
OUT:
GND: