Operation Manual

English _47
MAIN MENU
•Updating the Software
1. Connect a device storing the software to be updated. (It may take about 10 seconds to recognize the
device.)
` Upgradeable devices include USB memory and network device.
` To update the network, the current DVR should have been connected to the network.
Upgrade via the proxy server may not be enabled due to the restricted access.
2. Select <System Management> from <System> window.
3. Select <System Information>.
4. Press <Search> button to display updated image, then the <Search> button switches to <Upgrade>.
` The <Upgrade> button will be activated only if the current <Software Version> of the <System Information> is same to
or older than that of <S/W Upgrade>.
5. Press <Upgrade> button to display confirmation popup
for upgrading.
Press <OK> in the “System Upgrade” window.
` While updating, it shows the progress.
6. When the updating is done, it automatically restarts.
Do not turn the power off until it finishes restarting.
M
` If “Upgrade Failed appears, retry from the step 4.
When you experience continued failure, consult the service
center for assistance.
` When you perform S/W update remotely using Smart Viewer,
it may take a max of 3 minutes to complete the update since
Smart Viewer popped up a confirmation message. This is to
guarantee that the DVR set operates stably. For a faster update,
use the USB cable to connect to the DVR set.
Software Version v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Search
OK
Device Network
Version No S/W Data
DVR Name DVR
S/W Upgrade
System Upgrade
OK Cancel
Current Version v1.0xh_yymmddhhmmss
New Version v1.0xh_yymmddhhmmss
Do you want to upgrade?
Software Version v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Search
OK
Device Network
Version No S/W Data
DVR Name DVR
S/W Upgrade
S/W Upgrade
Software upgrading...