User's Manual

58
3.
Touch Add to Phonebook ➔ New .
– or –
Select Update if this was a previously created entry and you
are adding the current number to the previous entry.
4. Enter any additional information. For more information,
refer to “Saving a Number from the Idle Screen” on
page 55.
Adding Pauses to Contact Numbers
When you call automated systems, you are often required to
enter a password or account number. Instead of manually
entering the numbers each time, you can store the numbers in
your Contacts along with special characters called pauses.
To add a pause to a Contact:
1. Touch , and then touch the name to open the Contact.
2. Touch Edit and then touch the Phone Number field.
3. Touch the screen at the place where the additional
numbers need to be added.
4. Press and hold to add a two-second pause, and use
the keypad to enter the additional numbers.
Note: If more than a two-second pause is required, press and hold as
many times as needed to add additional two-second pauses.
5. Touch OK .
6. Touch Save to store your changes.
Using Contacts
Dialing a Number from Address Book
Once you have stored phone numbers in the Address Book, you
can dial them easily and quickly by either using their SIM card
location number or by using the Search field to locate the entry.
Note: The default Address Book entries are: AT&T Check Bill Balance -
*225#, AT&T Customer Care - 1-800-331-0500, AT&T Directory
Assistance - 411, AT&T Music ID - #43, AT&T Pay My Bill - *729,
AT&T View Data Usage - *3282#, AT&T View My Minutes - *646#,
and AT&T VoiceDial - *08.
Finding an Address Book Entry
You can store phone numbers and their corresponding names
onto your SIM card and your phone’s onboard memory. The two
locations are physically separate, but are used as a single entity
called the Address Book.
Contacts
a817 Blink.book Page 58 Monday, October 4, 2010 10:03 AM