User's Manual

Plug the data cable into the base piece provided and into

the Power/Accessory Interface connector on your phone.

Plug the base piece into a standard AC wall outlet.

When the battery is fully charged, the phone displays a

message telling you the battery is full. Remove the

connector from the phone.

Warning!:

If your handset has a touch screen display, please note that a

touch screen responds best to a light touch from the pad of your

finger or a non-metallic stylus. Using excessive force or a metallic

object when pressing on the touch screen may damage the

tempered glass surface and void the warranty. For more

information, refer to “Standard Limited Warranty” on page 180.

Note:

Failure to unplug the wall charger before you remove the battery can

cause damage to the phone.

Low Battery Indicator

When the battery is weak and only a few minutes of talk time

remain, the battery icon ( ) blinks and the device sounds a

warning tone at regular intervals. In this condition, your phone

conserves its remaining battery power, not by turning off the

backlight, but by entering the dimming mode. For a quick check

of your battery level, glance at the battery charge indicator

located in the upper-right corner of your device’s display. Five

bars ( ) indicate a full charge.

When the battery level becomes too low, the phone automatically

turns off.

Switching the Phone On or Off

Press and hold or until the phone switches on.

The phone launches the activation splash screen and then

proceeds to search for the network. Once the network has

been found, you can make or receive calls.

Note:

The display language is preset to English at the factory. To change the

language, use the Language menu. For more information, refer to

“Changing Your Settings” on page 51.

Correct

DATA LINK CABLE

Incorrect

Correct